Tamar Hannah is a woodworker in New Jersey with a YouTube channel, 3x3 Custom with some great videos illustrating great projects.

Lock the hex bolts back down, and determine if the blade is zero-ed out at both front and back.Rotate the blade back to the first position to verify that it is still at zero. I at first thought the warp table on my saw is a fluke and ended up in my hands.It will move back slightly when you re-tighten the hex bolts. WARNING: Before connecting the table saw to the power source or operating the saw, always inspect the blade guard assembly and riving knife for proper alignment. Tap the housing until the dial indicator is slightly past zero. My table saw is the DeWalt DW745 but you can apply the same principles to any table saw. Tap the blade housing with a mallet in the direction that the blade needs to move.On the DeWalt tablesaw that Tamar is using, the blade housing is held in place with two hex bolts.Actually, some people prefer to set the out-feed slightly wider from the miter slot (about. You want the fence to be parallel to the miter slot as well. Chances are, the needle is not on the zero anymore. You can also dial in the fence using the dial indicator. Rather than sliding the indicator to the other end of the blade, rotate the blade forward and move the indicator forward.Rotate the face of the indicator so that the needle is on zero, and lock it down.Index the caliper close to a tooth on the blade (but not on a tooth).Insert dial caliper in the miter slot and make sure the fit is snug.Raise the table saw blade all the way and then back it off about 1/16 inch.Step by step to align a tablesaw blade to the fence: Tamar uses an A-Line-It Kit, which is a dial caliper with an arm that rides in the miter slot of the saw. But it is a pretty straightforward fix. You do not need special tools to do this, you could do it with a combination square, but why use what you've got when you can buy a specialized tool, right? DeWALT Flexvolt 60V MAX Table Saw 1 Battery Kit Arbor Size: 5/8 inch Depth of Cut at 45: 1-3/4 inch Depth of Cut at 90: 2-1/2 inch Dust Port Diameter: 2-1. A relatively quick and simple method for cleaning up your tablesaw cutsĪn out-of-aligned blade can cause sloppy cuts and kickback.

How to align dewalt table saw